Encapsulating Asbestos A Safer Alternative To Removal — Intelligent Membranes

Encapsulating Asbestos: A Safer Alternative to Removal

Removing asbestos-containing materials is disruptive, costly and high-risk. Where the material is in good condition and unlikely to be disturbed, encapsulation — sealing it safely in place — is often the more practical choice.

Coating seals asbestos fibres in place

Encapsulation vs removal

The risk from asbestos comes from loose fibres being released. Where an asbestos-containing material is stable, undamaged and not friable, encapsulation locks the fibres in without the disruption, cost and exposure of stripping it out. Removal is normally reserved for material that is damaged, friable or about to be disturbed by other works.

What the regulations say

HSE lists encapsulating or sealing in asbestos that is in good condition as non-licensed work under the Control of Asbestos Regulations 2012. Non-licensed does not mean untrained: awareness training (UKATA Category A) is not enough for working directly on asbestos. Operatives need non-licensed work training (UKATA Category B or equivalent), with a written risk assessment and plan of work. Damaged or friable materials need an HSE-licensed contractor. Always start from a current asbestos survey.

The solution: a spray-applied encapsulation coating

Asbestos Shield (formerly Soteria) is an elastic, crack-bridging coating that encapsulates sound asbestos-containing materials — such as cement roofing, cladding and panels — behind a tough finish. It is weather resistant, so it can be left exposed inside or out, and stays flexible as the substrate moves.

How it is applied

  • Confirm the material is suitable for encapsulation from the asbestos survey
  • Prepare the surface following safe-working controls, without abrading the material
  • Apply Asbestos Shield to the specified coverage, using low-pressure methods where possible
  • It cures to an elastic, weatherproof seal; record it on the asbestos register

Benefits

  • Seals fibres in place
  • Elastic and crack-bridging
  • Suitable inside and out
  • Far less disruption than removal

Frequently asked questions

Is encapsulation always allowed? No — only where the material is sound and won’t be disturbed. Damaged or friable asbestos usually needs licensed removal.

Do I need a licensed contractor? Not for encapsulating sound material, which is non-licensed work — but operatives need non-licensed work training, not just awareness. Higher-risk materials need a licensed contractor. Follow your survey, risk assessment and current HSE guidance.

Read Asbestos Encapsulation: When Sealing Beats Removal, or get advice.

Back to blog