Containing Asbestos During Removal With A Peelable Coating — Intelligent Membranes

Containing Asbestos During Removal with a Peelable Coating

On an asbestos removal or strip-out job, the floors, walls and fixtures around the work collect dust and debris, and cleaning them down before clearance takes time. A peelable film sprayed on before the work starts catches that debris where it lands — then peels away with the waste.

Peelable film protecting surfaces during removal works

The problem: debris in the substrate

Removal works release debris that settles into concrete pores, joints and tape laps. Surfaces are normally protected with polythene sheeting and tape, which takes time to lay, can lift or tear, becomes slippery when wet, and all has to be bagged as asbestos waste afterwards.

How it differs from encapsulation

Permanent encapsulation seals sound asbestos in place for the long term. This is a different job: a temporary film that protects the surfaces around removal works, then leaves with the waste.

The solution: a peelable protection film

Surface Pro (20 kg) is a solvent-free film based on natural latex. It goes on pink, dries clear and flexible, protects for up to 4 months, and peels away in sheets with no residue. It is airless-sprayed on the non-asbestos surfaces in the work area. Where your risk assessment calls for a film directly over sound asbestos-containing material, use Surface Pro Brush or another low-pressure method.

How it is used

  • Patch test and peel after 3–7 days to check release (indoor use only)
  • Spray floors, retained walls and fixtures at a minimum of 0.5 kg/m²
  • Let it dry (3–6 hours at 15°C), then carry out the works
  • Peel in sheets and bag as asbestos waste where it has been in contact with asbestos

Benefits

  • Catches debris on the film, not in the substrate
  • Replaces polythene and tape on protected surfaces
  • No edges to lift and nothing slippery underfoot
  • Solvent-free, low odour

Frequently asked questions

Is this the same as encapsulation? No — it is a temporary protection film used during works, not a permanent seal.

Can it be used outside? No, it is formulated for indoor use and is not UV stable.

What training is needed? That depends on the category of work, decided from your survey and HSE guidance. Awareness training alone is not enough for working on asbestos-containing materials.

See the Surface Pro guide, or for permanently sealing sound asbestos in place, Encapsulating Asbestos.

Back to blog